I am in the process of completing my retrofit of AXYZ Millenium CNC. Thank you to some of the members here that had helped.
I have this AXYZ - Smouse Surface Tooltip Sensor and would like to wired...
Type: Posts; User: T2creative
I am in the process of completing my retrofit of AXYZ Millenium CNC. Thank you to some of the members here that had helped.
I have this AXYZ - Smouse Surface Tooltip Sensor and would like to wired...
Hello Russ, Thanks for info, I was able to configure ESS divers and establish communications with ESS and Mach3 with IDC to PORT1. Now the hard part is, I am not sure what C11GD OUTPUT/INPUT Pins to...
Looking for help in wiring ESS and C11GD Breakout Board by CNC4PC. There are a lot of information on C11 but not C11GD. The manual is technical and hard to understand for me. I am new to CNC and...
Here is the original wiring going to the break out board. Using pins 8 to 11
https://www.cnczone.com/forums/attachment.php?attachmentid=488714&stc=1
I measured the PIN 3VIN and it is 10v. Will direct connection like this work?
https://www.cnczone.com/forums/attachment.php?attachmentid=488708&stc=1
Thanks matec54,
I have an old AXYZ Millenium that uses this VFD drive with ELTe spindle.
I am upgrading to a more modern controller, the original controller is old, it requires a very slow...
Any cnc experts here that can help me with wiring vfd to a controller.
See attached diagram. Thanks
https://www.cnczone.com/forums/attachment.php?attachmentid=488688&stc=1
Thanks for the quick response. I went through the pdf manual, but cannot figure it out. Any one here have experience in wiring vfd please help. Thanks in advance.
Hello members, I have this Semipower DriveBlok ADM1003DCH00002 VFD and need with wiring to this Mach3 controller (see attached photos)
Searching online for diagram with no sesult. Anyone have a...