definitely smells like burning oil and is two 2.2kw single phase 220v pumps. They're junk because they do not hold down small parts AT ALL and I'm having to opt for tape.
Type: Posts; User: misterthi
definitely smells like burning oil and is two 2.2kw single phase 220v pumps. They're junk because they do not hold down small parts AT ALL and I'm having to opt for tape.
We recently purchased a StyleCNC router with vacuum table and it came with two generic vacuum pumps which do a good job at holding down a solid 4x8 sheet but doesn't really hold anything down after...
for our vacuums, we upped the number on the unit to 22, it came set at 12 and would always turn off after a few seconds. We kept having to adjust slowly until it was stable.
After a few weeks, glad to report our machine is finally up and running. The past 2 weeks we've been in communications with China to troubleshoot and tune. Once you get your machine, be sure to...
We have a new STYLECNC machine at our shop and have had similar issues, what we found was that the wiring was poorly done and some were loose. We took apart our contactors and gave them a good...
Our machine will finally be picked up from the freight forwarder warehouse in Dallas TX this week after so many delays, it's been a journey! Will post about quality and condition once we get it into...
Take the delivery promises with a grain of salt, I placed our order back in September and just now picking up our machine.
I just ordered a machine from StyleCNC, we submitted our payment through Alibaba for trade assurance instead if bank wire. The extra processing fee was worth the peace of mind.... Our machine is...
Our machine just arrived at port in Long Beach, CA and is en route to Dallas TX, should arrive by the 18th. Learned a lot importing for the first time from China and having to clear customs, used...
Theresa has provided me with the bill of landing and the shipment preparations, sent photos all parts and accessories getting crated. It's happening!
I requested the Mach 3 controller over the standard DSP. No doubt your ATC is much more than the one I purchased, I got a quote for the ATC as well when I was browsing but then opted for the 2...
I ordered a dual spindle machine, I requested they can be used interchangeably but found out during testing that it can only mirror cut therefor would limit the size of my projects by half, they had...
JMARTIN - I have a StyleCNC 1325 arriving in January, would it be possible for you to provide a photo of how you ultimately wired up the 220v lines? I bookmarked this thread, hoping to follow your...
Hope your CNC order goes smoothly. I put down a deposit for our CNC Router with dual spindle back in September anticipating our router would arrive to the states by December. As of right now our...