Post a picture of it so I can be sure to tell you correctly but I believe its a CMOS/BIOS battery. In that case definitely do not take it out. The second slot is either there to aid in replacing the...
Type: Posts; User: JR107
Post a picture of it so I can be sure to tell you correctly but I believe its a CMOS/BIOS battery. In that case definitely do not take it out. The second slot is either there to aid in replacing the...
Not sure exactly where it is on your specific machine but look for an air pressure sensor. I believe Hurco calls it an air pressure-detecting switch. Check the connections on the harness that...
Yeah feel free to send me a PM.
On a few of the older machines you can get some of the "real-time" positional data as well as spindle speeds through the RS-232 connections, and then you...
Out of curiosity, what are the fault codes on the Siemens controller after the shutdown?
One option would be using a break-out-board to get as many signal wires into differential pairs as you can. You will also need a down-conversion board to get them back into single signals. Also you...
To best clarify the comment about a disconnect between the software and machine code, I should explain where my mind is at. If, for example, Haas (or any other brand) decided to open their machine...
Funny you mention this; quite a few years back I bought an old machine with an Heidenhain controller for the sole purpose of trying to hack it. It was one of the only controllers that I could find...
A critical thing to note is that as 3D printer motion controllers become more and more advanced, their effectiveness with CNC machining work will diminish. The math involved in control planning...
I noticed this thread specifically a while back and wanted to throw some insight into the forums.
It is hard to pinpoint a good response since the initial disscussion/s is a more generalized...