Search:

I've got it working!

It did a clean install and followed the instructions directly but ended up in the same place. So I then went through and switched some wires around for example to use the X...

Thanks for the advice everyone. If I do end up changing the board - is there a recommendation for an all-in-one solution that is reasonably priced and doesn't require connecting to a PC / Laptop? I...

Thanks for all of the replies!

At this point I feel like l'm being pretty stubborn about trying to get the board to work. That set of instructions you sent through Vlod is way more detailed than...

Diagram attached.
Is this sufficient detail.or is more detail of each connection at the pin/connector level required?

The driver for the Z-axis is a newer model. ...

This has really helped, Thanks. I've now got the board working to some extent.
I can jog the X axis in both directions fine and it responds how I'd expect. Unfortunately I'm not getting any...

Thanks for the response Mactec. I noticed I didn't have the 24V supply connected to the Control board also earlier, so I changed that but it's still the same. I'm going to try to changing around...

I feel like this is most likely a Mach3 configuration issue on the Comms side. I don't think I have a good understanding of what information needs to be sent over the USB - My guess is that Mach3...

Yes. I have set the motor tuning to be the same as I had previously

Hi,

My old control board seems to have given up the ghost (NCPod), and I have bought a replacement, a Mach3 USB Motion Card (JDSW51B):...