Search:

Thank you very much for your answers.

Is it necessary to load the axis configuration program into flash memory?

After installing the program Kmotion, to each thread is already connected some program, how to remove these not necessary...

Although C Programs can be Flashed to KFLOP memory so they will be present in KFLOP Memory on Power up this is not normally recommended and not usually required. KFLOP normally powers up with no C...

Hello. I also have a thread question. The Kflop controller supports 7 threads, that is, simultaneous start of 7 independent programs with equal priorities downloaded from C files, if it is necessary...

The switch is an inductive sensor connected via an optocoupler board with a pull-up resistor.
http://www.cnczone.com/forums/attachment.php?attachmentid=384304&stc=1
If I use such a connection...

]Hello. For my machine you need 10 limit switches.
For this I wanted to use I/O 26-35.

ch4->LimitSwitchNegBit=32; //32-00100000
ch4->LimitSwitchPosBit=33; //33-00100001...

Axis X - 2 motors (linear)
Axis Y- 2 motors (linear)
Axis Z - 2 motors (linear)
Axis A - 1 motor (turning)
Axis B - 1 motor (turning)

I do not use Mach, only Kflop, Step/Direction Output Mode.
" KFLOP has 8 axes of Step and Direction." - text from KFlopManual.

Hi,how to set up to 8 axes? Trajectory Planner/Axis Parameters allows you to configure only the 6 axes