Search:

Aston Martin?

I forgot to mention...

Delta shows some torque curves in the manual. Looking at the infographic of "General Purpose", they appear to set the two Mids to the same frequency/Voltage and are basing...

I recently had a thread here where I was asking for help with a Huanyang Spindle/VFD. Everyone was very helpful. One thing that was mentioned was that 220V setup would be better. Mine was 110V.
...

I used the settings that you posted for me earlier in this thread. (Thanks again.)

Someone else sent a link to Automation Technologies where they listed basically the same settings you listed...

I just did a little more testing.

Using the pot on the control panel, the VFD only reaches 16020 RPM. Looking at the Hz it is at 267. This makes sense since 267 X 60 (mains frequency) =...

https://www.cnczone.com/forums/attachment.php?attachmentid=486084&stc=1https://www.cnczone.com/forums/attachment.php?attachmentid=486086&stc=1

Just in case I am missing something... which I...

I am finally to the point of bench testing my spindle / VFD.

As much as I would prefer 220V, I have the 110V, 2.2Kw spindle and VFD from Huanyang.

I have entered the settings provided by...

Oh wow! Thank you! That is very generous of your time. I appreciate it.

I am going to study up on this a little more. Someone told me once that the advantage of the VFD is that it has...

Ahh! Makes sense! Thanks!

Thanks so much for the reply.

I must admit, your response regarding the frequencies and voltages confused me even more. So I started going back through the thread again and I saw where you gave...

I apologize if this has been gone over before. I scanned the thread but I couldn't find it.

I am prepping to set up a HY 110V 2.2kW VFD to use with a HY 110V, 2.2kW, 400HZ spindle.

The manual...

Good point. I just happened to have the 1" stock. Maybe I'll see what I can find locally. Mild steel shouldn't be too expensive.

The aluminum bar stock is 2" x 1.5". I am not really familiar...

Greetings! I am a long time lurker here and this is my first post. I did a search but did not find anything.

First, I am not a machinist. I am a woodworker and I have limited access to metal...