Hi Bill,
Fanuc OM-B.
Thanks
Dan
Type: Posts; User: danSN
Hi Bill,
Fanuc OM-B.
Thanks
Dan
HI,
I need to drill a 2" deep 0.089" diam hole. I managed to do it drilling 1" deep 0.1" hole followed by the 0.089" one.
I do a peck cycle on both. By trial and error I realized that 0.089" has...
Hi,
I have a CNC LC-CV305 First-Taiwan, mill with a Fanuc OM-B control, no tape switch, no ladder diagram available or accessible. I have a few spare inputs wires in the cabinet, but no electrical...
Hi wyl6362708,
This is a CNC milling machine Model LC-CV305 serial 7710082. with a Fanuc OM controller, x 24 in travel , Y 12 in , Z 18 in.
Thank you,
Dan
Hi,
I'm looking for user manuals, diagrams .... for a First CNC LC-CV 305.
Thank you,
Dan
Hi,
Looks like Yashawa has this kind of drives and encoders. (motors with no halls). Motors are cheaper and hall are sensitive to vibration.
Dan
Hi,
I have a contorller that do not have any inputs for the Hall sensors.
In the same time the motor has the normal outputs A B C and 3 for the halls.
As expected the drive "complains" that...
Hi,
What is the best way to realign the encoder with a brushless motor.?
I had a good brushless with a bad encoder.
I allready install a new encoder but at hi pps the motor just stops (error...