Search:

I got it to work with just the SSR ,relay board still doesn't wanna work so I'm gonna go with the SSR only, I tried contacting CNC4pc a few times through email ,about the board, maybe I was missing...

Thanks I'll try that ,and I'll let you know how I made out

So mactec, you think I should try hooking it up jUst to the SSR and go from there

Here's more pictures

Yes it turns and here's a pic of the ssr

Yes I'm getting 5v and I was only gonna use the relay board but in the instructions it said to also use a solid state relay so that's why I'm using a solid state with the relay board....

Running 110v single phase.its just a 2hp porta cable router

Hello guys, having a problem with my spindle. I bought a C15 dual relay board to turn my router on/off and it was recommended to run a solid state relay also..so I wired everything up and and tried...

Hello guys, having a problem with my spindle. I bought a C15 dual relay board to turn my router on/off and it was recommended to run a solid state relay also..so I wired everything up and and tried...

Hello guys, having a problem with my spindle. I bought a C15 dual relay board to turn my router on/off and it was recommended to run a solid state relay also..so I wired everything up and and tried...

Last night I took out the breakout board to inspect it, I flipped it over and it looks like one of the circuits is fried if you look at where it says AC7 ,looks like there's something missing

I actually have moved that jumper to output...

Yes I did reset the eStop port and pin

Here's my wiring

I did the jumper wire on the eStop. But still doesn't work

Another thing I forgot to mention mactec54. If the e-stop is the issue, the dro's wouldn't move correct?

- - - Updated - - -

Ok I'll give that a shot..

Ok mactec54, what do you mean by jumping it

Mactec54, wouldn't the reset button on the screen be flashing

Kenrbass I'm using kl4030 drivers to run it

No e-stop just have it on pin 10 and set to active low

When I started this post I added the info in PDF my whole setup from connectings to leadscrew , motors ect.

The wiring I followed is for the c10 board with the kl-4030 here's the wiring, it's in PDF format

Thanks dazp for replying, the enbl +/- are not connected and no I don't have a physical e-stop yet

Any help..

hi, cnc brothers

I'm have a problem with my new build . i can't get my motors to turn , i do hear a high pitch sound coming from them but no movement, the DRO's in mach 3 does move. i'm pretty...

Thanks Mactec54

Ok Jim, I'm gonna take your advice on this one..thanks for your help

Jim my budget is about 1200

Thanks Britt , for all this info. I'm not running Linux I'm running mach3. Thanks for your help, now I know what I have to do. Thanks again guys..

Have to disagree with mactec54 on the absolutes, because I run a weeke 050 and a nester they both have absolute encoders and these machines know where they're positions are at all the time..