Search:

I have asked the Haas tech about changing the accel rate and they say that is very difficult if not impossible to do.

Hi Jim, Thanks we are going to try that. Shouldn't a typical hand held volt meter be able to detect voltage drop even if it is very fast?

I have a 2018 Haas VF2 hooked up to a Phase Perfect PT380 phase converter. The machine operates fine except when it jumps in RPM from 2500 to 5000 RPM. The machine shuts down on low power alarm 160....

Have you tried a variable helix carbide end mill at various speeds to get away from the resonant frequency of the heat exchanger fins? This might allow higher feeds or deeper cuts.

I use the Premier 600 coolant also and have had issues with staining on aluminum. The staining is a very light brown color. It almost looks like a coffee stain. I have never cut brass or copper, only...

I use a 6 flute 1/2" dia. carbide c'sink from Lakeshore Carbide on 6061 aluminum. I had the same problem until I drastically slowed the speed and feed down. I run it at about 600 rpm and very low...

Hi Ken,
I have a tension compression tapping head and the main difference is speed. You can tap a lot faster with the reversing tapping head so if you have a lot of holes to tap the reversing head...