This wasn't a "custom" from DMM, it's the 57N-DHT which they advertise as a 57mm NEMA 23. If you look at their PDF in the link below you'll see in the drawings that the frame is 60mm and the mounting...
Type: Posts; User: Belarusian
This wasn't a "custom" from DMM, it's the 57N-DHT which they advertise as a 57mm NEMA 23. If you look at their PDF in the link below you'll see in the drawings that the frame is 60mm and the mounting...
Thanks guys but I've already installed a set of iHSV57 180w servos and very happy with them. Still lots of fine tuning left on the servos and rewriting some of my macros to compensate for the rapids...
Long story short, the motor is too large to allow for ANY clearance for bolt heads to fit in the NEMA 23 spacing. Impossible to tell from the motor drawings online that this would've been an issue....
I took a long break from working on the router (burning out and other commitments) but I'm back with another update video. This time I'm happy to report that the machine is now capable of automatic...
Sorry to bring this thread back from the dead but I'm curious if you've done any more work to the machine. The custom boards and control panel are a very nice touch.
Has anyone found where I can buy more of the square M6 nuts that this machine came with? DIN557 appears to be smaller, no luck finding any other standards to go off of.
Made another video going over the progress I've made upgrading the X6 with an ATC spindle and my UCCNC electronics. Whats been very pleasant is that the X6 router required minimal modification so...
Update, didn't notice but the newest version of the plugin came with a PDF with settings for the E300 which worked just fine for my Simphoenix E550 VFD. VFD parameter 4.00 had to be set to 0104 and...
Hello Dan,
Thank you for the work you've put into this plugin.
I've been having a difficult time finding the register values for my Simphoenix E500 VFD. I'd really appreciate if I could get some...
For the last few weeks I've been building a new electronics cabinet for my X6-2200L centered around a UC300ETH and UB1 breakout board. Just recently I figured out VFD speed control and decided to...
Anyone else having issues with Mach3 making the machine plunge -5mm below the origin every time you 'go to zero'?
I've worked around the issue by probing the tool just before I cycle start but it's...