In my opinion it is important to know weather you want to manually jog this motor or to position it on command
Sent from my Le X522 using Tapatalk
Type: Posts; User: ArturoMoises1
In my opinion it is important to know weather you want to manually jog this motor or to position it on command
Sent from my Le X522 using Tapatalk
You need to reinstall mach3 and void the parallel port option, then go through the proper plug in
Sent from my Le X522 using Tapatalk
Why would you want a driver serial port? I think the parallel port cards work just fine, usb even better.
Sent from my Le X522 using Tapatalk
I think you should get a breakout board, your computer might be putting out 3.3volts. You can find one on ebay with relay output for your spindle and coolant pump.
Sent from my Le X522 using...
It sill not rin any slower... Same power, I have ran many 1hp 3phaze motors with 120 volt vfd.
Sent from my Le X522 using Tapatalk
You can buy a 120vac input vfd to run a three phase motor, I have only seen them up to 1hp. I just found a few on ebay up to 1.5 hp but there could be a mistake.
Sent from my Le X522 using...
The software is Quickset 4.2.48
I had to make the serial port cable, the connection on the drive is numbered but not marked, I couldn't find any numbers on the drive nor on the manual. I had to...
Sure Mike, just let me know how to post videos on this forum. Or I could post it on Youtube and then pass the link on to you.
Arturo
Hello
I am new (again) to this forum, I was looking for help on the Teknic drives I find that I am not alone, I pulled my hair for a week until I got them to work, I don't particularly like drives...