I have a MultiCam SF 44 machine with original motherboard and controller. Today I am getting "Z-axis out of bounds" on any job I try to run. The machine homes just fine and also will run a "Dry Run"...
Search:
Type: Posts; User: chris7682
Search: Search took 0.00 seconds.
-
02-04-2020, 06:06 PM
Thread: SF Series "Z" axis OUT OF BOUNDS
by chris7682- Replies
- 0
- Views
- 656
SF Series "Z" axis OUT OF BOUNDS
-
05-04-2012, 09:47 PM
- Replies
- 0
- Views
- 382
Multicam SF48 Firmware Order and Location
I have a SF48 (MC48SF31474) machine. 6-7 months ago I had my Motherboard and and controller replaced with the latest and greatest (that would work on my aging router) The down side. I got the...
-
05-04-2012, 07:36 PM
Thread: Looking for old tool holder 94-01804-00
by chris7682- Replies
- 10
- Views
- 581
It's a CNC Machine...
I have found with just a bit of time. A good set of Micrometers and a Multicam router. I can remake most of the Multicam consumable parts at a fraction of the cost and usually end up improving the...
Results 1 to 3 of 3
