I have a torq Cut 22 and I am having the problem that when I run a program at the moment it loses and damages the pieces making lines and radii, any idea what it could be.
a photo to give you an...
Type: Posts; User: christian7r
I have a torq Cut 22 and I am having the problem that when I run a program at the moment it loses and damages the pieces making lines and radii, any idea what it could be.
a photo to give you an...
https://www.cnczone.com/forums/attachment.php?attachmentid=420230&stc=1https://www.cnczone.com/forums/attachment.php?attachmentid=420232&stc=1
that's the voltages that he gave me when I measured...
ok I will check all the voltages right now the two transformers are set to 230v
Thanks
https://www.cnczone.com/forums/attachment.php?attachmentid=420120&stc=1https://www.cnczone.com/forums/attachment.php?attachmentid=420122&stc=1
hi months ago I bought a torq cut 22 and this week I connect it and when I give it to enable the drives they activate the contactors and they are deactivated and I get the axis drive fault alarm,...
I have not done it yet I asked if someone had done it.
I saw one that I want to mount but I have a doubt the engine encoder is only for the RPM or it is also used for the position of the spinder...
The vfd drive can be replaced by a universal one
I wonder someone has changed the vfd to a torq cut 22 for a universal one other than the yaskawa and another question that works does the encoder that is under the transmission
ok thank
I'm checking a step up transformer 208v to 480v
A question like did to update the DOS and install the window is that I bought a Torq cut 22 a few months ago and I want to update it and make a backup on the hard drive and also buy a solid state...
I did that without connecting the VFD and since everything turned on the spindle motor says on the 400v board, I read something that the axis drive faul alarm is because the vfd is off so it does...
for the spindle and the VFD I will have to install a transformer 208 to 480v
it's already on but I'm having a problem when I give the drive the enable it is giving me an alarm (Axis Drive Fault) that could be causing this failure
Thanks
greetings I could not answer but I'm back the voltage in my house is 230v and configure both transformers to 230v and I could turn on the electrical panel without turning on the VFD or the...
Ok
if it is something strange because the vfd is 230v and the spindle motor says 400v
I think the single phase current is 240v I have to measure it to see how much it gives me
the coolant pump...
photo of the VFD and the spindle motor
The VFD input is 200-220v/50hz 200-230v/60hz
I'm trying to upload a photo but it will not let me try later
not only do I have a small rotary phase that I use for the conversional milling
I acquired a torq cut 22 that was installed at 480v and where I am going to install it there is no 480v converter that I recommend or how I can install it to make it work
thanks for your help