So I hooked up the power supply and gecko, but the servo seems really weak. I played with the PID trim pots over and over and got it as stiff as I could without oscillating. I am able to twist the...
Search:
Type: Posts; User: trilo68
Search: Search took 0.01 seconds.
-
03-11-2018, 05:41 PM
- Replies
- 5
- Views
- 1,629
Re: Leblond tape turn electro-craft permanent magnet servo motor-tach
-
02-04-2018, 01:02 AM
- Replies
- 5
- Views
- 1,629
Re: Leblond tape turn electro-craft permanent magnet servo motor-tach
Thanks for the reply. Any thoughts on encoder resolutions? I have some 200 ppr and some 1000 ppr. Also unsure of voltage. I have a 70VDC supply and a G340 gecko drive that I was going to try testing...
-
02-03-2018, 08:50 PM
- Replies
- 5
- Views
- 1,629
Leblond tape turn electro-craft permanent magnet servo motor-tach
Looking to add “modern” nc to my old tape turn. It does not have any no on it now. The servos run by some hand dials that have either a tach or resolver on them that go back to the amplifiers. These...
Results 1 to 3 of 3
