The PPR on encoder is 5000.I should probably use only 5000 PPR or 2500 PPR and reduce CMR by half.
My main concern is will the sensing of the new encoder be of any problem.
Type: Posts; User: sepganesh
The PPR on encoder is 5000.I should probably use only 5000 PPR or 2500 PPR and reduce CMR by half.
My main concern is will the sensing of the new encoder be of any problem.
We need to replace a ROD 426 5000 Axis encoder.My doubt is how does the controller sense the encoder.Will any TTL encoder with equivalent pinout work as a replacement.
Hi Everyone,
We got a used Cincom E16 which we are refurbishing.
The machine is missing the collet chuck sleeve,the two sleeves behind the collet sleeve and spring.
Please let us know if we can...
Hello Everyone,
I have a failed Tamagawa encoder.
OAER FA-CODER
OAER:5K-1X-3-8-108
TYPE:TS5850 N60.
Can this be replaced with any other encoder as there is difficulty in getting it repaired....
I bought an used Tsugami NP 32 but the machine came with no manuals.The machine has a Fanuc OTT-C controller.Can someone suggest where I can get the manuals(at least the operating and programming...
The drive for the Turret 1 goes into alarm no 52 on the MELSERVO-SC 102T servo drive.Does anybody have the alarm list to understand the reason for the problem?Going by the fact that these drives are...
Hi Everyone,
Thanks for the ideas.We could get the slides into position only after setting free tool layout pattern as it would not recognise pattern 1 & 2 already stored in the Tool Pattern...
Our Takisawa TC 20 works with M89 for id clamp and M88 for od clamping.for id clamping input m89 and cycle start and you are good to go.
Dear Mike,
Thanks for the response.I am ok with working inch system.
On trying with inch mode,"No tool comp data " message appears when trying to select any program.
When trying to move to queing...
Hi,
Just got a used CINCOM 3M7 L20(the one on front of machine says L16) ,year of manufacture 1994.The seller in US had loaded the parameters new as the machine was not switching on.
When we try...