504,607 active members
4,032 visitors online
Register for free
Login

Search:

Type: Posts; User: cmtas

Search: Search took 0.00 seconds.

  1. Replies
    18
    Views
    870

    Re: Fanuc 10TF System Error

    Yes I tried "7" and "9" also, found on another post. About 1 out of 5 times I am getting "b" when holding "-" and "." On power up. Very strange not being consistent. Most of the time it's "o".
    ...
  2. Replies
    18
    Views
    870

    Re: Fanuc 10TF System Error

    Please understand I am not at the machine now, so I had my friend do the power up holding the "7" and "1". Then power up holding "-" and ".". At no time did anything show up on the monitor. However...
  3. Replies
    18
    Views
    870

    Re: Fanuc 10TF System Error

    As I said earlier, IPL mode is not accsesable. There is no screen output. Memory clear has been performed several times. I will try again. Be aware this system is Fanuc 10TF with Fapt, I don't know...
  4. Replies
    18
    Views
    870

    Re: Fanuc 10TF System Error

    When first booting display shows several different letters very quickly (i believe this is normal), always ends with small "o" as pictured. All segments are working during boot. None stuck on or...
  5. Replies
    18
    Views
    870

    Re: Fanuc 10TF System Error

    Yes I have backup. Confirming it is small "o" not "c".408246
  6. Replies
    18
    Views
    870

    Screen is blank. No response to try to get to IPL...

    Screen is blank. No response to try to get to IPL mode. pulled battery to clear memory (30 minutes). Always shows small o on 7 segment display on main board.
  7. Replies
    18
    Views
    870

    Re: Fanuc 10TF System Error

    Screen is blank. Monitor is on with only garbage (lines no text). When the fiber optic cable is unplugged from CRT/MDI controller, red lights appear on controller. Otherwise one green light. I did...
  8. Replies
    18
    Views
    870

    Fanuc 10TF System Error

    A friend of mine asked me to look at his Dosan CNC lathe with Fanuc 10TF control. What I found was a undocumented system alarm on the main board. It is displaying a small "o" , not to be confused...
  9. Replies
    1
    Views
    544

    Parameters for colchester CNC 2000

    Need NC parameters and diagnostic parameters for Clausing Colchester CNC 2000 lathe with 0T control. Can not find machine information plate with date and serial number. Machine has no turret, tools...
  10. Replies
    0
    Views
    206

    Ultra3000i E60 Error

    Have a E60 error on my Allen-Bradley 2098-DSD-020X-DN Ultra3000i drive. Has any one seen this before? I can not find anything about this error. My local A-B tech was stumped. Ultraware sees the drive...
Results 1 to 10 of 10