Search:

Don't be sorry, I don't know much about all this, and I appreciate a lot your reply!
Any advice and comment means a lot to me!

Now I need to pratice making drownings and g codes, Some drownings...

Thank you lovebugjunkie for reply !

I fix my problem, I set steps per mm to 368, velocity to 600 and acceleration to 200 and now everithing is ok, I can change speed by changing the feedrate in...

Ok, I found the way to make islands, but now I have other problem..
Today I was trying to configure my machine with Mach3 and have one big problem.
When I move motors with hotkeys, they move fast...

Hi all,
In March last year I started to build Linistepper for my machine. At that time I started a thread here:...

I try the bob and linistepper with kcam and it works like charm.
I am so happy now...
Now i can start with the mechanical part of the project .

Finally!

My linistepper work, I made a circuit with 74hc14 chip, and the motor is spinning half round every second ( depend in what stepping mode ) all stepping mode are working. Thanks a lot to...

Thanks James !

I have a question : Is there any way to step motor without connecting driver to pc, to see the driver board is working ?

When i power it up, motor get in hold position ( stay in...

Thanks for the tip, I did not think the power resistor will be so warm, I will extend the wire of power resistor.
I got the pic, so now I can start with the cables. I hope that I will not merge...

Hello everyone,

I'm a little stuck with the job and have less time for the CNC project, but here the situation is coming to an end.
I solder all the elements on linistepper and the interface...

Yes, but I decided to make a new pcb, and resets the elements.
Now I added pins for tuning resistors.
Thanks for the advice !

http://tvsb.diyplans.org/slike_razno/77.jpg...

James, you was right, i've never worked with such a large resistors so now, when i got it, i see that i have a little problem with them, in the reality it is much larger than the eagle drow on the...

Here is pcb
http://tvsb.diyplans.org/slike_razno/lini.png

Thanks, it is toner transfer, top layer is toner transfer too.
I will put power resistor in vertical position and between each other will be about 5-6 mm.
I don't plan to drive motor bigger than...

Here is my progress with linistepper.
I used brd from Sam Waters and squize it a little and add few vias.
I also replace crystal with ceramic resonator like on the original schematics.
Board is...

James, thanks for your response, your answer has confirmed my desire to make linistepper.
And big thank to Roman, for sharing his knowledge and information.

Sincerely,
Tomislav

Hi everyone!
For a long time i try to create the CNC router, for my hobby (r / c models), I made ​​different drivers, but I have not yet managed to put together something that works.
I spent a lot...