Search:

Hi, I'm new to this forum, I need to connect a diode laser to my brekout bord but I don't know how to do it, there is someone who has done it and can give me info for connection and settings on mach3...

my laser has three wires a positive a negative is a yellow wire which should be the ttl signal it worked in pwm without any additional card because it has its own, on the 3018 card it had a specific...

Since you are very kind and prepared I would like to ask you how to install a diode laser that I had on my cnc 3018, I would like to put it on my new cnc with mach3 system the spindle I command it...

So my parameters are fine my spindle motor and 0,8KW 220v 6,5A 400HZ is my VFD 1,5kw 220v 7,0A 2,8KVA

These are the parameters stored on my Vfd

P00.00=400

P00.01 = 0

P00.02=0

P00.03=0

These are the parameters stored on my Vfd

P00.00=400

P00.01 = 0

P00.02=0

P00.03=0

Which parameters determine the heating of the spindle and its good functioning so I check and let you know the ones that I have set

Hi I'm new in this forum could you share your settings to make the air cooled spindle work not to heat it controlled by VFD YL620-A

Hello as I am new in this forum and I would like to understand my cnc machine well I followed the discussion regarding the vision of the spindle speed and I set those parameters to be able to see it...

If on 00.23 you put 400hz the spindle marks 6000 rpm as the maximum speed, if you put 60hz the spindle reaches 24000 rpm

Enter on 00.23 = 50/60HZ it depends on where you are in Italy and 60hz
Enter on 00.24=0
Press the program button to return to the frequency, then press nine times on set until you reach RPM...