Try $10=3
Type: Posts; User: k_yarina
Try $10=3
Have you tried the grbl_esp32 wiki?
It has a very active G+ group
Michel Bevin is a spammer that makes this same post in multiple forums, including one I moderate. Not likely to benefit the community...
Yes, it is scary. You put your life in somebody else's hands while being completely unable to do anything about it.
The last thing I remember is them saying "Lets get started", then woke up...
Glad to hear the surgery went well! I also had surgery a few months ago, on my stomach. Still sore sometimes, and have a big scar, but am much better than before the surgery.
Hoping your surgery goes well; do what your doctors and nurses tell you to...
Ouch! Heal quick, back pain is miserable
Basic debug skills. It slams into the stops? Why does it move too far? Part's too big, wrong units (mm instead in inches, for example) or your steps per (inch, mm) are wrong. G540's 10 microsteps...
Like manyhats said you need the normally closed estop terminals jumpered and the charge pump switch off until you get the computer connected.
These are both safety features, so when you hook up...
8 days.
Kirk
Hoping gold would turn green was wishful thinking.
I heard back from Simon at repraper.com, they'd misread GD for GN and shipped gold instead of green. He offered to ship a replacement if I...
My 6kg from repraper arrived today. All the PLA was the correct color (black, white, red, blue (quite dark), natural), but the spool of green abs is actually a medium brown color. Will it change...
I ordered 6kg from reprapers.com on 4/9, they shipped on 4/11, sent the confirmation email tonight, and FedEx shows it in Memphis and arriving here on 4/17. 5 kg of PLA and 1 of ABS, $86 and $72...
The Xylotex board is an old design, has no static protection, a short warranty (90 days vs 1 year for the G540) and no out of warranty repair.
I purchased an unassembled router that came with an...
Sean, was that an official printrbot parts kit?
Printrbot's update #20 discusses the doublewide at Printrbot: Your First 3D Printer by Brook Drumm » Updates — Kickstarter .
As a backer...
Is it still under warranty? Have you tried contacting Grizzley?
Inkscape has a gear generator, and the gcodetools extension can generate gcode from drawings.
I'm a Gearotic Motion owner/user, and strongly recommend it. The beta version can generate graham...
I have a Zenbot Mini with a G540; no problems at all with installation or configuration. It takes a bit of hand-eye coordination to solder the resistors into the DB9 connector, or see Soigeneris's...