You must have sofware in FDD 1.44mb disk
it cost 1000-1500e from Hurco if your hard drive damaged then ask hurco for soft they will quotation for you.
Type: Posts; User: noexit
You must have sofware in FDD 1.44mb disk
it cost 1000-1500e from Hurco if your hard drive damaged then ask hurco for soft they will quotation for you.
maybe you know that parameter to set that i can donwload view ladder?
https://imgur.com/a/73fOPlI
like you see in link there are M50 but i dont know how to activate it
Thanks for response i will try to take ladder but it is password protected, DMC 635V 2006 milling machine .
I try to search web for password and return
Hi Everyone
Machine DMC 635V fanuc 32i control.
i want to add airblast from M code activated, i asked Deckel Maho but they say that it is not possible for this machine, but i don't believe....
This not work I try.
Sorry in video this was not my best try.
https://youtu.be/bN9TOGNii54
But I make 2 hard drives working only this way
- - - Updated - - -
This not work I try.
Sorry in...
in fanuc it is table of tools maybe yoiu want to take tool that doesn't exest in tool table?
Dear
Can you write that machine yours year, that language from code i think it is fanuc.
Thanks Bloke
Only this was bad and needed this 4 numbers , and error code 128 that was hdd connected to secondary master on Motherbord.
https://youtu.be/bN9TOGNii54 <--- here is my 2.15 soft and...
hello
My problem is this, I have a BMC2416 which when turned on says:
then i reinstall soft of hard drive fail i get error 128 time out on screen
same disk but on computer makes loading...
Problem was wire that make shorth then we found it was ok, now just have one HDD imige copy
1. RAM
i take off all ram and add just one stick, but it not works if i add 2 then it works.
2. On this board no capacitors.
Now will try to connect extra monitor directly to pc
Unconnected I/O...
Dear
Can somebody help
Hurco then i start about in random time enters freeze and only shut donw machine help
here in video you can see everything that hapens....
my V2.15 ultimax 3 i have dongle, but i can't put better software, then V2.15? Because drilling for positive very annoying
how i want this soft :) i have virtual disk of 2.17 soft
can you make for me 2.21 ?
I have mastercam
Does your software of machine use positive driling?
Dear
You makr runing this machine? I have same machine but only ultimax 3
Išsi?sta naudojantis SM-G960F Tapatalk 4 Lt
Hello
You turn out machkne and turn on again.
If yes and same i think plc out signal sending if you cleaned everything
Išsi?sta naudojantis SM-G960F Tapatalk 4 Lt
1. First i take off belt to see that it runs without belt, but make marking.
2. If servo runs without then problem in mechanics if not then problem in servo side.
3. Servo side need to take of...
Dear I hade similar problem
Try To go to spindle presing F2 then ATC diagnistic,
Then you see all posible operation that you can do
Try look at buttom ATC not at HOME position
then write...
Maybe some one have 2.16 software for hurco 2416, i can share i have older soft 2.15 in that no industry standart
Hi i have hurco 2416 satisfy about that machine, maybe you by same?
no one figure out this problem?
Or only use teamviewer?