Is that a DOS or windows version? If it’s Windows It would be very helpful
Type: Posts; User: rc-worcs
Is that a DOS or windows version? If it’s Windows It would be very helpful
BUMP.
I have the same issue.Any help would be greatly appreciated.
It should work, but I would need a copy of PRONC and the installation key to try it.
Also I have RemoteWIN but no serial key. If you have a key I can try it for you.
that was painful!
I have ISELDRV.EXE now. I cant seem to post it here. I shall try and message it .
I contacted Key for the same question - to update the machine, I would buy it tomorrow if it worked. They have tried to integrate the UPMV card in the past, but had some compatibility issues. They do...
I have a copy, I am just trying to install the USB drivers on the win98 machine so I can get a copy. I'll post it when i have it.
NEEDED : ISEL FC-1200-IS spindle drive/controller manual. Preferably in English.
I can find the later mdoels but not this one.
many thanks.
I thought I would post an update on the GFV machine in case it is of use to someone...
Well I took the servo axis apart and traced all the wiring at that connector, and then took the rack unit...
Thanks I have tried there. They have a few of the manuals for the internal cards, but not the pinout for the 19" rack, or the safety module.
Could anyone point me in the direction for getting a manual for the ISEL PV CV-3 servocontroller. Specifically the pinouts for the servo axis connectors on the rear.
I've tried the various ISEL...