Search:

what motor tuning setting do i enter in for all 3 axis. I have the following hardware on my g0704.


(2) KL-6050 Bipolar Stepper Motor Drivers (X and Y)
1 - KL23H2100-50-4B (3/8” Dual shaft...

What dip setting do i need to setup if i am using a Nema 34 motor ? runs super slow. how to speed up.I have gecko board on a heat sink.

well see what happens. and i wanted to finish my mill this weekend but something always happens.

I just pulled out the ball screws out of the box. i ordered them less than a month ago. .Didn't install them on my g0704 since i didn't have mounting kit so i forked out $700+ on the CC to find out...

what oversize balls can u repack ball nuts with for zero backslash? i have this kit.

New Ballscrew Kit G0704101015 for Hoss G0704/ BF20 CNC Conversion | Automation Technology Inc

no picture or schematic?

Anyone know how do u wire a G201X to C10 Bidirectional Breakout Board ? this is the electronics i am using for my mill


2) KL-6050

(1) G201X for Z axis

(1) KL-600-48

(1) C10...

I still havent received a email back.

This is the ballscrews i have
G0704 CNC Update Machine Ballscrew Kit G0704121212, with nut for B-G0704M | Automation Technology Inc...

anyone wanna makes some and make some money

ok thanks i sent him a email

Do you happen to have Billy's from BDtools email?

Anyone wanna make the 3 mounts that hold up the ball screw in the bed.. X and Y and Z .. I am Willing to pay for them. . I have the outside plates where the motors are mounted so i just need the...

kinda looking for some free plans or a diagram .

Anyone have easy plans to make the inside mount for ball screws and end plates for all AXIS for a G0704 mill? or anyone wanna make me the X and Y and Z mounts that go inside the table?

Where to buy a better/Aftermarket Drill chuck for G0704 mill. stock one with mill has way too much run out..

thanks... LOL thought i got a defect..

I just bought this from little machine shop the hole inside the cap seems to be off center. should i return for money back and go buy a US made collet chuck.? Or is this normal? I'm a newbie..

take any video or the milling?

so what do u need to spin the spindle at 7200 RPM..

can u post more picture of the clearance issue? .how u mounted the pulley on the spindle..I might buy the same set up for my MIll..

Hoss what do u recomend for very heavy duty milling of Steel and aluminum? what size stepper motors do i need?
Can u used this motor to replace the one i have on my g0704?

Automation Direct...

Can u put up the link to that project that they made there own mill with the tormach head..thanks

Has anyone tried this before to bold Whole assembly?

Can you use a Tormach Spindle on a G0704? What about there spindle motor and belt system? I'm a newbe and just bought a new G0704..

I have 15K Cash I'm looking for a Haas Vf-3 older unit Or a Fadal 4020 older unit... I'm located in Souther California I would like to keep price at 15K or less including being shipped to my garage.....