Search:

Problem solved, low voltage at BOB due to loose connection. Thanks for looking

I have stored my motors and drives for about a year and when I set one up to test it it doesn't run. The thing that appears wrong is that when I plug the printer cable into the BOB the led on the BOB...

I have a 6 axis bob question about the jumper settings. I understand that the jumpers JN1 and JN2 isolate the 5vdc from the DB25 (computer) from my external power supply. However the J4 jumper I...

I have a treadmill motor and controller that has an 4N35 input for PWM. The 6 axsis BOB I have has 5v 25ma output on the output pins. I want to us this output to drive the led in the 4N35...

I have been looking at stepper motors on the internet and the motors all have an amp rating, but it doesn't say whether the rating is RMS or peak. Do most manufactures use RMS? What is the best way...

I have the motor and all the parts out of a sears tread mill. the motor is 130VDC and 2 hp. It has a MC_40 motor control board and the board that plugs into the console. On that board there is a pin...

I am looking for sources for replacement wipers for a VMC 15. Thanks

I am working with a used VMC 15 we just got and when I look in the manual from Fadal it shows a lube pump, however this machine only has grease zerks.
Some on the -X end of the table and some up by...

Thanks for all the quick replies. I will get a chance to try your advice this weekend and let you know my results.
Thanks again,
Mike Lyons

Hello.
I am new to this forum and new to cnc programing. I have access to a Fadal vmc15, and I want to enter a short program from the keyboard. I have entered individual program lines and ran them...