584,866 active members*
4,847 visitors online*
Register for free
Login

Search:

Type: Posts; User: mouse1942

Search: Search took 0.00 seconds.

  1. Replies
    17
    Views
    13,571

    My issue is actually slightly different. I...

    My issue is actually slightly different. I accidentally changed a parameter when trying to change the backlash compensation. As we all know when you change a parameter the first time it alarms out...
  2. Replies
    17
    Views
    13,571

    I am also in the same situation. Would anyone...

    I am also in the same situation. Would anyone with the 0-TD parameters please send them to me?

    Dan
  3. Replies
    15
    Views
    524

    Re: Help with setting up Mach 3 on EMCO mill

    Bugger lol oh well i think it will sell it before i go that far although i did want it going before i did this. Its to small anyway really for what i want to do every job i go to put on it is too big...
  4. Replies
    15
    Views
    524

    Re: Help with setting up Mach 3 on EMCO mill

    Yep that was my first port of call , i have pulled the table off and cleaned and re oiled it.
  5. Replies
    15
    Views
    524

    Re: Help with setting up Mach 3 on EMCO mill

    They are square steppers. I have tried both climb and conventional. The dia of cutter is irrelevant considering I'm only talking about side load not end load. Yes i could try a 1 mm depth of cut but...
  6. Replies
    15
    Views
    524

    Re: Help with setting up Mach 3 on EMCO mill

    OK so i have tried dropping the steps down to half step with no change it still skips steps. I know I'm loosing steps because it cuts over size if i cut a OD or under size if i cut a ID. Jon the...
  7. Replies
    15
    Views
    524

    Re: Help with setting up Mach 3 on EMCO mill

    Hi Russ , yes the gearing reduction is on both x and y and even on z . when not powered i can wind the gears over smoothly but no i cant push the table. i will try 1/4 stepping and see if that helps....
  8. Replies
    15
    Views
    524

    Re: Help with setting up Mach 3 on EMCO mill

    Hi Russ, I purchased these steppers along time ago but from what i can remember they have 380 Nm . They replaced older steppers that where half the size of these. there is also a timing gear...
  9. Replies
    15
    Views
    524

    Help with setting up Mach 3 on EMCO mill

    Hi guys I picked up a EMCO mill a few years ago and replaced the electrics to bring it into the 21st century. Now the issue I'm having is that I'm loosing steps under load. I have tried all the...
  10. Replies
    3
    Views
    1,045

    Re: Stepper Motor Help

    Thanks for the reply H500. after looking over it all again i have worked out the magnets are off set by a small amount so when you turn it around they press on the end of the housing making it cease...
  11. Replies
    3
    Views
    1,045

    Stepper Motor Help

    Hi Guys, could anyone quickly answer my question. I have a stepper motor with duel output shafts one being 7mm Dia and the other end 5mm Dia. Now the problem is that i need to turn the stater around...
Results 1 to 11 of 11