I went with 3/16 polycarbonate -- I had TAP cut it to 27.75, 8.25 (in) but I needed to cut it down a bit from there to get a good fit.
Type: Posts; User: fremder23
I went with 3/16 polycarbonate -- I had TAP cut it to 27.75, 8.25 (in) but I needed to cut it down a bit from there to get a good fit.
I've been looking through those files. There's a fair bit in your directory -- I guess I haven't gotten to the tailstock alignment part yet.
Well, now I know about dual plane balancing. Are the two planes in question the end-cap of the actuator and the ring of set-screws about 3/4 of the way down the body of the cylinder?
On mine, the small window just slid out of the tabs that were holding it in (slide to the left, if you are facing the front of the machine). I had the big door off at the time, though.
Mine...
Hey, look at that. Here I thought I was just here talking to myself. Then I take a break for a few days and everyone shows up.
@crclark -- It took me a while to get my spindle to turn on, too. ...
A Ha! Thanks a ton for that bit of information. BTW, we're practically neighbors. I'm in Scappoose.
While I was ignoring my computer, I made a lot of progress on the EMCO re-hab.
I got the tailstock back together without any hiccups.
Getting the tool turret off was a bit of a pain -- I had to...
My suspicions about the tailstock proved to be true. It was quite stuck but judicious application of the arbor press sorted that out in relatively short order. I didn't have time to clean it up or...
I've made a bit more headway on the Emco lathe. Things have very much been 'two steps forward, one step back.'
After a lot of googling, I discovered the correct 'cold start' procedure. That...
Some progress on this Emcoturn 320 rehabilitation. I've got it mostly cleaned up. Now that I can see all the fasteners and such, it is time to start addressing the functional problems.
I got the...
I, too, have recently acquired a used Emcoturn 320. The previous owner said that the X-axis seals and bearings need to be replaced. I haven't even begun to address that issue at this point. I'm...