That's it, pin 31 to change mode, but I can't get it, that's why I thought that maybe you have it more in hand to see if you could try it with some servo that you had around send me the file, of...
Type: Posts; User: madmondi
That's it, pin 31 to change mode, but I can't get it, that's why I thought that maybe you have it more in hand to see if you could try it with some servo that you had around send me the file, of...
Good afternoon CNCMan, thanks again for your interest, those two servos in particular are going to be used in a small tabletop lathe, they are going to be handled by an own design based on the...
Works too in W7
Yes, I got it, now I just need to configure it according to the manual or if someone with more experience than me has a file of a driver of that type working, read it from their driver and share it,...
Good afternoon CNCMan, in that manual there is no cable diagram, but it is very simple, it is an RS232 Nul Modem serial cable, I have used it with a USB RS232 CH340 converter and it has worked the...
Hello again, after three years I have finally found the software for this driver, the manual is the one from the link that Roberto sent me to, from here thank you very much, I have found the software...
Good evening everyone, I write these lines to ask for help, I have got two panasonic drivers of the EX series, very old, the driver in particular is the MSD011P1EC03, and the engine is the MSM011PJA,...