584,833 active members*
5,596 visitors online*
Register for free
Login

Search:

Type: Posts; User: chrsbrbnk

Search: Search took 0.01 seconds.

  1. Replies
    146
    Views
    13,537

    Re: New Fusion 360 limitations

    quote By the way, my annual expense is $340 on special. Difficult to beat.
    Marv where did you see that price? thanks chris
  2. Replies
    3
    Views
    13,021

    Re: absurdly long toolpaths..

    In running back to back comparison between fusion 360 and mesh cam the mesh cam has much longer mill times with much worse finish lot of those week long kinda things radius's seem to...
  3. Dmm's tech Tianyu, suggested switching drives or...

    Dmm's tech Tianyu, suggested switching drives or cables this lead to finding a poor crimp on the y axis cable from the breakout board to the dyn4 on the breakout board end reworking the...
  4. dyn4 servo creeping or twitching along by itself

    I tried wiring in the recommended approach for servo disable signal connecting the 14v pins together on the J4 connector and connecting the ena pin 15 to pin 1 . this approach worked on the X servo...
  5. Replies
    1
    Views
    1,011

    home/limit switch questions

    The application eng. at Dmm said the home- limit switch would be located in the center of the travel of the table then the pc/breakout board limit the travel by counting. I was wondering if the...
  6. Replies
    3
    Views
    1,224

    The Mery engine is often run on propane there's...

    The Mery engine is often run on propane there's a print for the mixer out there somewhere since a horde of the hit&miss models a run on it
Results 1 to 6 of 6