Search:

Help Please.I am trying to setup my a new KRS servo controller and Hicon interga. I can make the servo rotate in both a positive and negative direction with PN003 set to 1, but I can't seem to make...

Does anyone have a 3d drawing of the G0704 image they would be wiling to share. I can draw it myself but I would like to save time.

Please share if you do.

Thanks

Thanks I will break down the drawing in the area's where I will be working and confirm the measures over the next few days and get back too you

Sent from my SM-G950U using Tapatalk

Good Evening All,

I have been searching for a wireless pendent to use with Mach 4 and haven't found any good information. Can anyone point me in the right direction?

Thanks

Help anyone....

I just received my new HiCON Interga board and I am have a hell of a time setting it up.

1st I tried to contact directly to PC, I changed the IP address as per the manual and no...

Yes, it good. I had been running the example codes with the motors disengaged from the mill and completely regenerating the toolpath. Now I only get a very small portion of the toolpath and it...

Good Evening Gents,

I'm put coming up on the completion of my G0704 Hoss conversion, and tonight for the 1st time since putting the system back together. I tried to run the example G-codes that...

ger21 thanks for the advice...

I have found that I can now get about 240 ipm from my Z. I have found that the system seems to run best at 45khz with a velocity setting of 6000 and acceleration...

I will try that tonight I didn't know I had to restart the software after I changed the kernel speed I am running at 25khz now . I am not running in demo mode.

Sent from my Pixel XL using...

The supply was a 48vac 60 amp supply that I installed a 100 amp bridge rectifier to convert to DC. Sorry I miss spoke it was used to run 8 stepper drivers simultaneously. The thing weighs about 50...

Hello Gents,

This is my 1st post so please be gentle.

I am converting my new G0704 using Hoss's phase 3 plans, and am having a hard time getting more then 90 ipm. I am using Windows XP,...