Search:

It was up but now it's down again.

It's like an umbrella in Arizona, down more often than it's up.

It seems to have a high failure rate and each time it happens there is less expectation that it will be restored.


I thought David might have checked in here by now.

It looks bad.
Table '.\cbforum\smf_sessions' is marked as crashed and should be repairedTable '.\cbforum\smf_sessions' is marked as crashed and should be repaired

CamBam website down again

Yes I know now.

You have to change the "Boundary Margin" parameter, it is related to the tool diameter. Start with a number equal to tool radius then make it bigger if that is not enough.

I don't know why it is not reaching the specified depth

Does anyone know why it was down ?

Jim,

Just out of curiosity, why didn't you ask this question on the proper CamBam forum ?

I've attached a cb file that shows one way to make the item in CamBam, it was created using CamBam v1.0
It uses a variety of machining operations, spiral drill, 3D waterline, pocket, profile, all...

No, you posted a message on CamBam but didn't check back again, there is a good reply waiting for you there.