Thank you Craig!
Type: Posts; User: ryghar
Thank you Craig!
Yes it does!! very cleaver. I will check that!
Thanks!!
Excelent, I think I got it.
I will try and see what happend. Anyway, here in Argentine you buy what you can, not what you want... (in this case i buyed without knowlege), worst scene.
Its my first...
Thank you so much guys!!
Last two xD.
1- In other thread i saw that 48v can be "too much" to half coil. Is that true? If I undertand you correctly, as much voltage the better an the driver will...
Please, tell me if Iam wrong with this:
- According to the datasheet the motor has 4 phases and 1.6mH/phase. So, in full coil config, has 3.2mH
- The power supply, according to what I research,...
Hi,
I have a 6 wire stepper motor. The datasheet specified 1.6mH of phase inductance and 3A. This values are for full coil (middle tap unconnected) or half coil (start and middel taps connected,...
joeavaerage , I cant thank you enought for the time you spend in that answer. Invaluable for me.
By "parallel bipolar" you mean connect the coil start and middle tap or the start and end taps and...
Sorry, one more questiona. The motor works and 3v. Do I need to setup something to this?
The motor is 3A. That is RMS or Peak?
Thanks for your patience
Thanks for your reply.
I allready have a cnc at shop and some basic experience using it. The budget is set, I know what to buy and have the plans to do it.
My concerns are in how to setup the...
Hi,
Iam building a CNC based on openbuilds design. I have 4 wantai 57BYGH633 motors with DQ542MA drivers.
The CNC will have 1000mm x 500mm with two motors on Y. Belt driven and leaded Z.
I have...