Search:

Thank you for the reply, Yes after RAM check it turned to b. And the PMC is the ROM cassette. Is that saying my PMC-ROM cassette is causing the problem?

Thank you for the reply, Yes after RAM check it turned to b. And the PMC is the ROM cassette. Is that saying my PMC-ROM cassette is causing the problem?

Hi everyone,
We have a Mori Seiki MV-55 w/Fanuc 10 control. It has occasionally faulted with either a PC010, PC020 or PC500 alarm. Rebooting the machine would usually clear the alarm and all was...

UPDATE:
I was able to load the parameters (SRAM1_0A and SRAM1_0B) by going to the correct "status screen" which is the delete files option (?) where it gives the choice to delete or restore, I...

Haha... NO, the screen is fine! As a matter of fact I got the control to boot up after replacing the power supply card that I got from fleabay with a new one from genuine Fanuc!
Now the remaining...

Thanks folks, I will try that... I did try adjusting the power supply up slightly but that did not help. -Tony

I have a Fanuc 0i Model C in a Tongtai Turning Center that is dead, no display and no Status LED's on the main board. I have 24vdc at the board at CP1, both fuses on the board are good. I have...

the Boss 4 logic power supply has several test points for regulated and non-regulated voltages, the regulated measurements should be close to their rating (+/-5%)? And there are couple of...

Tazzer, I was wondering if you got your MillPwr problem resolved, and if so, what was causing the Estop condition? If you are getting axis drift at power up, then the enable signal from the CNC to...