My 2006 Haas VF-2B has coordinate rotation and scaling but, yes, for some reason, with G150 the pocket sub-sequence does not also rotate. I had several vise stations that were 180 degree rotation so...
Type: Posts; User: math_indy
My 2006 Haas VF-2B has coordinate rotation and scaling but, yes, for some reason, with G150 the pocket sub-sequence does not also rotate. I had several vise stations that were 180 degree rotation so...
The newer Haas lathes allow G00 with "E" where "E" is a percentage of the rapid motion feed rate. For example G00 E10. Z0.; will move to Z=0.0 at 10% of your rapid rate.
Mathews Engineering offers an aftermarket spindle brake for TL series lathes:
https://www.mathews-engineering.com/store/p24/Spindle_Brake_Kit_for_Haas_TL_Series_Lathes_MY2016_and_newer.html
I too was plagued by Haas Spindle Drive Fault error 123 and, after much effort, I am happy to report that I think this vector motor drive is finally fixed. It was very difficult to work on because...
Here's a good tip for using operator's coordinates on Haas to get results similar to G43:
To move the zero to tip of tool when using Operator's Coordinates:
Do a tool change to force the machine...
Haas VF2B USB Keyboard and Interface Adapter, Mathews Engineering part number HKBI01 is available on ebay. It should work on most other Haas machines that have the same or similar control...
I also wanted to disable my tool changer on a Haas VF-2B. I have a $6000 Dorian right angle tool and I don't want there to be any chance of dropping that tool or trying to change it into the tool...
I was getting the coolant spigot failure alarm (code 196). After a lot of time fussing to figure out what was wrong, I determined that something was wrong with my PCOOL gear motor. There are four...