584,866 active members*
5,236 visitors online*
Register for free
Login

Search:

Type: Posts; User: GLWDAVE

Search: Search took 0.00 seconds.

  1. Re: Post Processor for Multicam 1000? Using Vcarve Pro

    Hi Mathew is it an australian Multicam machine that has AXYZ controllers ? if so i might be able to help
  2. Re: Multicam (AUSTRALIA) Series IIs router - Help needed setting up

    Hi
    If any of you guys have a multicam hand controller you want to sell message me please
  3. Replies
    5
    Views
    3,311

    Re: WANTING TO BUY ENROUTE 4 or 5 SOFTWARE

    Hi
    Is that AUD or USD
  4. Replies
    5
    Views
    3,311

    Re: WANTING TO BUY ENROUTE 4 or 5 SOFTWARE

    Hi Cah
    How much do you want for it ? I have not long purchased Vectric Aspire.
  5. Replies
    0
    Views
    2,155

    AXYZ Ram card Wanted

    Hi
    Looking for axyz parts AXYZ AMC004g ram card and possibly a board
  6. Replies
    1
    Views
    2,348

    Re: Spare parts from retrofit

    Hi Kenrbass
    Have you sold the motherboard and ram chip
  7. Replies
    5
    Views
    3,311

    WANTING TO BUY ENROUTE 4 or 5 SOFTWARE

    HI
    Does anyone have enroute 4 or 5 Pro they dont use and would like to sell
  8. Re: Designer Series Gantry not sitting Square on side rails

    Hi Guys
    Spoke to multicam today who said the gantry must have jumped a tooth in the move . Told me how to fix it . Thanks for the replies
  9. Designer Series Gantry not sitting Square on side rails

    Hi
    Just purchased a 2002 designer series 2400 x 1200 table
    The gantry dosnt sit square on the side rails so not all bearings are touching at the same time. When i measure from the gantry to...
Results 1 to 9 of 9