Search:

I have waited over 13 months before going this route, and to be honest, it pains me to do so. I ordered a Predator machine from George (InMotion CNC) in Mar 2021, and I am still waiting for the end...

Hello all. I am making a "grave stone" for a pet that has past and I have been commissioned to create a grave stone for the garden. I will be creating a pocket to place a clay paw print in (about 2...

Hello ladies and gents. I spent 20 minutes trying to find the correct forum group to post this in and I think that this was the closest I could find. I was searching the web for a new Brass plate...

By height, I meant length x width, not z height. I will check out those out.

Hello all. So here comes the question that I am sure everyone at one time or another has asked. Does anyone know of a good, all-around, laser engraver (or at least a good manufacturer) that can be...

Roger that. I think I can handle this. If I have anymore questions I will let you know. I GREATLY appreciate your help in this. I went from clueless to actually understanding. Thank you very...

OK, I think it if finally sinking in. It was confusing me with having two SSR's. If all I am interested in is the router, I guess I would only need one SSR, is that correct. The second could be...

Sorry, I didn't read the post prior to your last one. I am using a router that plugs into the wall so I am not using the power supply in any capacity in conjunction with my router. Provided I am...

OK, so I need the power supply, 2 of the SSR's (the same type for both I am assuming will be OK), and the wiring between the components, is that correct. Will I also need to setup Mach3 in any way?

Would this 24VDC PS work
https://cnc4pc.com/hardware/power-supplies/24vdc-0-7-amp-15w-ac-dc-enclosed-switching-power-supply.html

Is there a chance that my current PS for my MX3660 would have a 24VDC output that could be used for the SSR?

OK, I am part of the way there as far as understanding. From what I am looking at, am I going to need another power supply??? I think I understand the DC relay, but where, how, and with what does...

Let just assume for a moment that I have not got a clue about what you guys are talking about. I wired my Controller board up for my machine, but it had directions and I only had to connect wires...

I have the Leadshine MX3660 for my control board/Stepper drive. Does this help?

Still looking for this mystery relay. Any ideas where to get one?

Ger21, do you know where I can get the relay?

Hello fellow CNC enthusiast. I was hoping you could help me with something. I have an XZero Raptor that uses the normal Hitachi router that I currently have plugged into an extension cord. I would...