Oh, I see, thanks. So it does not matter at all if I use 12V or 24V?
Type: Posts; User: nejc1337
Oh, I see, thanks. So it does not matter at all if I use 12V or 24V?
For the 12-24 V power input on the breakout board, what current do I need to choose? Is 24V1A enough or should I go with 24V5A? Thank you.
Thank you. :)
I still need some help. :)
So, this is what I have:
- 48 V power supply
- 4 of these: https://www.ebay.com/itm/264045184820
- 6 limit switches:...
Thank you! And thanks to everyone who helped. :)
Thank you, but I will go with these motors now: https://www.ebay.com/itm/NEMA23-23SSM8440-Closed-Loop-Stepper-motor-2-2N-m-101mm-4A-Servo-Driver-HBS57/163907492964
I get it, thanks. I don't have any clue of what the torque should be because it's my firat time doing this. It's important to point out that most of the work will be done on a smaller scale, say...
Yes, SFU1605 ballscrews (5 mm pitch) and SBR20 linear rails.
What do you think about these motors with 1,8 mH: 57CM23 version:...
Thank you.
Thank you. What about that UC300 from the link I posted? Is it okay? And then I do not need a breakout board or do I?
Thanks.
I understand. So it IS better to look for lower inductance motors in my case when the drivers (DM542) don't support voltages over 50 V?
Ah, okay, I get it, in that case I am leaning towards UCCNC...
Thanks, guys!
@ger21, 1st answer: Ok, I understand that. But nothing "bad" can happen if I use 36 V instead of 62 V, right? And, if I understand correctly, it is then best to look for motors with...
Thank you.
So there is no problem with using the motors with 6,8 mH and then having the 35 V power supply? Okay, thank you about the M3.
What about the drivers, are the DM542 okay?
If anyone...
Hello.
I am building my first CNC router about 1000x1000mm big. I have some questions regarding electronic components since I do not have much background about this.
1. I was looking at kits...