Search:

Have you found a solution for this yet? I would like to set up something similar

I plugged the mono jack into the edge finder port

182342

I have a Millpwr III MP3 controller and made an edge finder for it, So the cord you are looking for is a mono cord. The switch is open until the edge is found.

I have a Millpwr 3 on my KentUSA knee mill. When I bought it I had to travel from Southern California to San Francisco. After I got it home and powered up, it was working fine, but after about a week...

Then I would say you have a solid foundation.

I personally have a KentUSA CNC with an Acu-Rite MillPwr 3 III control. (Bridgeport Clone with 3 axis control) It weighs 3700 lbs. I had to move it...

I noticed that the base of this system is attached and leveled to the bracket on the wall of the basement. First Post. First Picture

From what I see from the outside looking in is, there has been...

my bad the reply was on a different post where the Router table was massive I beams and attached to the wall

Hi All,

Sorry I posted a response in the wrong area. Hope you all have a good day (Revised)

Best regards,
Vince

Hi Folks,

I am in the process of making an electronic edge finder for my MillPwr 3 III, So far I have the holder and switches and have temp wired the switches to test. I will use this approach to...

One issue I am experiencing once and a while is my graphics display will scramble. I have opened my control and re-seated the graphics cable and that seems o take care of the issue.

As for the CF card, from what I gather it has to be formatted as FAT which has a max size of 4GB. I have a 1GB inside and a 4GB in my card reader. I tried a bigger card 32gb with no luck formatted as...

I have a 2008 Kent USA KTM-4VKF with a Acu-Rite Millpwr 3 III control.

I am using a rs232 to ethernet adapters with a 25 foot cable and a usb to serial converter with windows 7 running in a...

So you have waited all year for an answer,

I also have a Acu-Rite Acurite Millpwr 3 III (for future search engines) and when looking at what was inside the control I found a 1GB Flash and an...