Search:

FYI, I figured it out.

M19 RS=45
Make sure there is a space between 9 and R
45 would be the angle

M19 orients the spindle to "zero" for the tool change operation. Is there a way to orient the spindle and lock it at a specific angle/rotation?

Thanks! I'll pass this info on to our maintenance team.
I've only ran a few jobs through the machine. Nothing that was really pushing the load. Now the part that I have setup in one of the other...

I changed the main and the sub to the largest chuck that was available and it added 5 seconds to the cycle.

Yes, I checked this. All the machines are set at 100% for the torque limit value.

With the sub spindle open, M151 less than 2 seconds.

That's correct, even without the spindles synced together...

hmmm

Good morning,


We have another new to us 2012 OKUMA LT2000EX Serial #163297 machine.


The main spindle is not the "standard" or the same size as the other 2 machines that we have. It is...

We have an 2010 LT2000 EX with Y axis on the upper turret. The upper turret slammed into the side of the sub spindle in rapid. We were able to align the Y axis guide rails. But we can't get the X...

Got it!
The problem was not with the negative code it was in a different part of the program. I wish that it would highlight the code in the program!


The number of characters following address...

Okuma LT300 OSP-100 control


I have a combination tool that has 3 inserts. SEE ATTACHMENT

1 is an OD tool to radius and face off the tube

2 55 deg back turning insert

3 .125 wide ID...

Ok thanks for the replies!

Now I was looking and this control has only "TIME" as an option on the tool life management page. Is there a way to change that to pcs? So that we can count the number...

We are wanting to use the breakage detection function. Sub-program name"OO30" on our horizontal Okuma MX-40HA mill with OSP-U100M control.

The machine has the touch probe that is mounted to the Z...

We have a couple special combination tools that have a small diameter drill protruding from the end. I want to check the tool length from the registry that it is within a certain limit. So that if...

I'm using the lower turret to machine on the sub spindle. When it is done I switch to G141 and send turret all the way to limits. The parts catcher won't come down if I don't. Then I want to be able...

Your inbox has exceeded the limit. I can't send you anything until you delete some thing.

I sent you a PM, OkumaWiz.

I don't know how you (DeadlyKitten) replied with the balloons.

"i am just saying costs with materials are low in most cases"
The extra part that we are not getting out of the bar is costing us...

Thank you for the bar feed program!!

How does the schedule program change how my program "runs"?
The schedule program will run my program the same as it is except it won't be using the GOTO loop....

I am using the GOTO loop because that is how it was programmed for us by an Okuma rep. and all the programs from the previous owner are also setup that way.

How do I setup the schedule program to...

We purchased 2 used lathes one with OSP-P200L control the other OSP-P200LA. I'm not totally fluent in the programming of these machines yet. The problem is I moved a spot, drill and tap from the main...