Search:

Thanks!

I will take a closer look next week. Other than not being able to set the servo following error to factory specification the machine seems to be running well.


Actually I am fairly...

I have not touched the wiring, it came from 3x400V shop and my shop is 3x400V as well.

Servo amp big blue capacitor measured 168 VDC while all 3 axes were moving.

Yes i do.

I managed to get one machine running allthough there is weird issue.

I performed full calibration to the axis drive system starting from feed clock test.

I cant seem to set the...

Hi!

I have several basket case fadals im working on and I have question about 1010 axis cards.

465680


What are these plugs and why some cards (X, Y, Z) have them and some don't? Also...

Very interesting project, thank you for detailed photos.

Are you looking for more speed or more rigidity or just matching OEM spec with rails?

Have you seen anything like this before? 2004 VMC-15 XT with 7500rpm spindle.

The drive was still barely working but lacking power and smoothness. Especially deacceleration sounded very strange....

There is about 11.70VDC over blue cap.

120VAC can be found from the other side of large solid state relay next to bridge rectifier which should provide this +170V

This machine is 1997 Fadal VMC15XT with 88HS control

When doing CS after powerup i get

X axis servo amplifier fault
Y axis servo amplifier fault
Z axis servo amplifier fault

Error number...