I recently bought a Cincinnati sabre 1250 vmc. The structure LM guides and ball screws are in a very good condition. But the controller and the servos needs replacement.
So, this is my plan..
X...
Type: Posts; User: kamaldeepsing
I recently bought a Cincinnati sabre 1250 vmc. The structure LM guides and ball screws are in a very good condition. But the controller and the servos needs replacement.
So, this is my plan..
X...
Hi,
I made a oxy fuel cutting machine using stepper motor and Mach3 .I am having a problem with torch on/off and pierce delay. Generally mach3 is programmed,,, first the torch gets on and then...
I bought 3 stepper motor 57BYGH115-003, interface card . when i connect the interface card with driver and motor, i checked the interface card pin 2(DIR) and gnd and did get 5v when i press left key...