Search:

Thanks for your comments Dan B, we don't do anywhere near the volume your place does, I can see why automation is key. We would have to contract out any API programming.

at the time, Early 90's...

We have a seat of NX that has the 3axis mill foundation on it but no one knows how to use it. I did some training on Myigetit.com but even then, its a PITA. We got it because it was a cheap way to...

as a long time customer(25yrs), I wouldn't be surprised either. at $9+k a for 1seat Full License with 5axis and 3 seats Workxplore.
we don't do simultaneous 5ax enough to justify it in my eyes.
...

Is there any chance someone can convert these to igs or step? I believe they contain Geometry, but I don't know.

if you're cutting with under 20mm , I'd go with 10k or more

For example. If I put a 4-inch block on the table, I want the Z offset to be 4 inches. Our acromatic2100 controller can do this with the spindle probe. The Haas machines comes up with a neg Z number....

Is there an option on Haas mills to make the table the Default z0 rather than the spindle face in home position?

That's how we have all of our Fanuc and Siemens based mills setup.

We have a VM6...

We've got an old Acu-Rite Millpwr 3 3axis controlled Bridgeport knee mill. It still requires a floppy disk to load programs into it. It still functions but floppys are a pain in the....
I'd like to...