Search:

Resolved:

Eding responded that there was an 'endif' statement missing in my macro, things seem well now.

Hi,
Now I have this. What is Run-Sub? It happens after one MDI entry of a toolchange effort, then continues each time, as if a subroutine is going on without stopping potentially.
I will revise...

Thanks,
I think you were right.

I am setting up the cnc760 on an Avid cnc.

My machine has begun showing a message about the master slave distance being violated.
During setup operations, it was previously ok.

The variable...

This is resolved. I had implemented this advice:
https://support.edingcnc.com/support/solutions/articles/43000651445-after-homing-my-machine-coordinates-are-not-zero
I had added a " G53 G0 Y5"...

Hi,

I have prepared an M6 compatible ATC macro for a test, it shows the error message "not allowed in state HW-V" What is the meaning?

Thanks,

Some of the M6 macro is below, it did not let...

CNC760 board + relay board from cnc4pc

My Aux 2 relays (two off of one output) are open collector, they energize upon startup, then will follow the spindle command. Temporarily I have set it up to...

Hi,

I am setting up the cnc760 on an Avid cnc, which is a fairly flexible (not rigid) router. The setup has been fairly straightforward and nice so far.

I see that my maximum slave axis...

Hi,
So the increment buttons on the controls for rates are 25%, I want them to be 2% for my application. It is very useful to make 2% changes to cancel harmonics, and even make minor feedrate...

This sounds familiar enough I thought I would mention. I spent 1+ years diagnosing odd Z axis drifts on mine since new. It turned out the post in Fusion360 was for "Mach4" When I used the "Avid"...

I can offer 1 phase, 50 amp, 240v at that location, not 3ph though.

Hi,
I am upgrading a 2.25hp router on my 4848 CNC. I see many Chinese spindle/VFD combos, Vivor, Jianken, unbranded etc.. What I do not see is user feedback here or anywhere else reliable as to...

Hi,
I am considering a chinese VFD/spindle kit from ebay, etc, for about $700. Is there any repository of reviews or setup guides for such spindles?
Is there a, perhaps, taiwanese, or italian...

CFandZ, Quite interesting. I have had the same problem since 5/2020 when I bought the machine. Some of the following notes may be helpful to you in diagnosis.

Here is what I discovered:
Stepper...

Hi,
I am building a CNCRP 2x4' machine, and I have plenty of CNC experience, however lasers are new to me. I want to cut birch plywood, up to 6mm thick. It seems trivial for me to:

1)attach a...