Hi friends! New challenge in my machinist life, this time we bought a Mikron wf 54 vh with TNC 415 and when I try to operate it in Manual or Program Run mode every time when I press the Start Cycle...
Type: Posts; User: Fluckar
Hi friends! New challenge in my machinist life, this time we bought a Mikron wf 54 vh with TNC 415 and when I try to operate it in Manual or Program Run mode every time when I press the Start Cycle...
hi! it might be for 4 axis but you have connections only for 3.
if you need the board as a replacement part for a machine that has 4axis then it should work just take a picture at the connections...
Update 2
Hello guys! My electronics friend was able to come and make some further tests...during those we found that the 2nd board that come in pair with the drive, one is with integrated circuits...
UPDATE
So, the power suply drive is Bosch 038035, when starting the machine by pressing Feed ON button his green LED turned off and a red one lights on, the one that specifies DRIVES, ok, so in...
Hello! I've got some experience dealing with TNC 407 milling machine for 6 years, maybe the drives of the axis match.
So you got a plasma machine that don't move...where you been able to traverse...
I've managed to upload the video:
https://youtu.be/g1SKJGAc_0o
on this way you may take a glimpse of what i'm dealing with. :cheers:
Also I'm still waiting your suggestions!
I will come with a video of the symptoms soon. ;)
try to post the picture again, we don't see it here.
or try to make a video with the behavior of the machine.
i'm haveing some experience with this operating sistem so maybe i could help you!
Hi guys! My boss bought this Mikron with TNC 407 operating sistem from an auction and it has this problem. When I push F -ON for refeance points and then Start cycle it apears a feed (numerical, ex....
The operating system is not user frendly, is a little bit tricky at the beginning until you get use to it. It can support program transfer from PC to CNC via serial port RS-422.
I have managed on an...
If it worked before it may be a sensor fault. Wen you start the machine enter in PLC-MON and hold the keys for rotating the tool magazine, if on the screen you don't see "1" in two places blinking...
Estop(s) are pulled out and a few times we shut it off from the breaker to.
Hi guys. I'm in desperate need of help...yesterday we've moved our shop location and machines. we''ve tested our Mikron if it starts and if the phases are corect linked in the electric table and it...
it is done, N should be grater then 9000 and after that it will save the program.
I've tried with N200 because previously I worked on a Philips 432/10 and there was no problem with N200.
Thread...
Hi guys! I have to deal now with a Maho MH500 C with Philips 432/9 operating sistem and my question will be, how to store a program to its memory?
I've tried folowing the next steps: manual -> part...
Hi guys, I have some devices on my employers machine and I don't know what are those used for. I attached a photo to be more precise, the thing is about those two black faced cylinders under the...