508,246 active members
2,551 visitors online
Register for free
Login

Search:

Type: Posts; User: Creativeguy

Search: Search took 0.00 seconds.

  1. Thread: wondering

    by Creativeguy
    Replies
    5
    Views
    348

    Re: wondering

    "Is it possible to model up a solid in ezcam?"

    No, you can only create surfaces in EZ-Cam.
  2. Replies
    2
    Views
    600

    Re: Spindle will not turn below 225 rpm

    I've had the machine since it was new. I did verify the orientation factor hasn't changed.

    I suspect it is the Baldor controller. I hoped that someone else had the same issue and it was less...
  3. Replies
    2
    Views
    600

    Spindle will not turn below 225 rpm

    I'm having issues with a Baldor ( ZD18H220Y/D 15H 10K rpm) on my 1996 6030 Fadal. I suspect it is related to a low speed issue. The spindle will run and stop as normal, but I can't get the spindle...
  4. Replies
    6
    Views
    498

    Re: Z axis off .009 over 12 inches

    Here's what I found out. The machine has comp tables for all 5 axis. Using the SV commands, I found the Z table was corrupt. FADAL sends comp sheets with the machine, but only for the X and Y axis....
  5. Replies
    6
    Views
    498

    Re: Z axis off .009 over 12 inches

    When I checked the Z axis and how much it was changing, it was on a single point on the table. The error is proportional to the distance. About .00075 per inch which leads me to think it is some kind...
  6. Replies
    6
    Views
    498

    Z axis off .009 over 12 inches

    I ran into an interesting problem on my 1994 Fadal 4020. I was machining blocks to a height of 6.000 . When I check it with a height gauge it was small by almost .005 I thought it may be a faulty...
Results 1 to 6 of 6