Search:

Using a Metrol tool setter. It's setup for off the center of the pallet. I guess I worded my question poorly.... Say we have a 4.00" standardized length tool in the spindle. Does that 4.00" begin at...

When setting a tool, what point does the measurement of the tool begin? The spindle face?

So yes it is auto. MDI is a simple M60 for pallet change, but I can't integrate it into a running program.

No need for M30 being as I am picking up the program after the M0 stop prior to the M60...

I am currently trying to use an in program pallet change to install bushings after boring an i.d. We have a mori nh4000dcg. program after machining prior to pallet change is as follows: "G91 G0...

I am receiving a "ex1976(3): Spindle Sensor Alarm" on our NH4000 MSX-501III. I've changed batteries in the probe. I cannot turn the probe on or run any type of canned cycle.. Any ideas??

With 9031 alarm, I'm getting alarm #31 on the drive. After resetting both alarms go away, then I get the 9000 with "--" on the spindle drive.

I am climb milling with a 5.0" slotting cutter and am getting this error when exiting one part and entering another. .500" depth of cut, .3125 width of cut, ductile cast, 382rpm, 7.0 ipm. I was...

I recently put in a new Metrol tool length setter on our NH4000dcg. I made the mistake of turning away when touching off a tool and came to realize there was no tool in the spindle, causing my head...

I recently put in a new Metrol tool length setter on our NH4000dcg. I made the mistake of turning away when touching off a tool and came to realize there was no tool in the spindle, causing my head...

I am watching it run at this exact moment. WITHOUT an "I" or "J" specified.

Thanks.

Allowing .01 for a finish cut: i.e. "1.0569".

I did have numerical errors due to object snap on AutoCAD.

Proper working program:
G3X-2.5769Y.74J-1.0569
G1X0Y-1.8595
X2.5769Y.74...

Forgot to add that to the thread. The issue is at both interpolations.

I'm currently running through a first trial of a program using G03 interpolation on an outside radius of the attached PDF file. I've drawn the part out in autoCAD and gotten coordinates through that....

I'm currently running through a first trial of a program using G03 interpolation of outside radius of 27/64. I'm getting the error msg: "over tolerance of radius". I've come to the start point of...