Search:

Any suggestions on hard boring the attached part. I would need to bore the .569 dia. and come down to the .6308 dia. and bore across and do the backside .569. I would like to do this all with one...

No will be running on a Citizen Swiss machine.

Quoting a job out of condition B 316. Was wondering how it machines compared to just 316. I never ran any of the condition B. It will be turning and threading.

Thanks it worked out well

My machine does not have the LFV but with the G75 i am looking to do kind of the same thing. I do it all the time on our Fanuc controlled Lathes. I am just looking to straight turning, I have tried...

I have a Citizen L32 with a mitsubishi Meldas series 500 control. I wanted to use the G75 cycle for chip breaking in the Z axis . I keep getting a program error and I am not sure on what format to...

I need to broach a T25 hexalob anyone have any experience with this. From what I read it seems as though it can be difficult. I will be able to cheat a little on my hole size material is 1144. I will...

Im running an older Citizen L32 5/8 416 material not ground but within .0003 roundness . I'm turning in one pass 6000rpm .003 feed down to a .4945 dia. over 1.5 length to a shouler then up to a...

Ok thanks I was worried that it would hit the block for the sub spindle( tools 31-34) when I come over to use the 4 position drilling stations (tools 11-14)

415188

Has anyone ever added a double spindle right angle live tool to there A20 and if are you still able to use the 4 position drilling station and your back spindle block or is there to much...

Yes I am using a .015 radius .I have tried DOC from .050 to .200. Just cannot get it to be consistent. I can run 6-7 parts with no problems then the next 3 will have chips.

Machining 17-4 PH Condition H1150 on a citizen swiss. Having trouble breaking chips. I have tried whizcut inserts and sandvik . Was looking to see what other suggestions are out there. My trouble...

Thank you for your help. On the thread I was thinking of getting ground stock to the major diameter (.373) and threading it in a few sections at a time and coming in and supporting with the...

New to swiss machines. I have been working on a citizen a20. I was wondering if it is worthwhile to try and single point a thread 4.5" long. Also my max chucking on the machine is 6.5" for one chuck...

I am getting a short part on my citizen A20 with the CAV barloader. It will run fine for awhile and then I will get a barend that is about 5" shorter than the others which gives me a short part. I...

Thanks for your reply. As i am new to the swiss machines I have another question you may be able to help me with. Since the collets on this machine do not have any keyways for location are htere any...

Was wondering how to program for a rectangular pick off on the citizen swiss. Is this best done with just orienting both spindles or is there a setting to be able to sync both spindles and have it...