You can download that software version from the Heidenhain website
Best regards
Type: Posts; User: wardygb
You can download that software version from the Heidenhain website
Best regards
Hi, the error says the difference between actual position and programmed/expected position is too high. Are there any other alarms ?
Any errors on screen ?
Hi do you still have this problem?
There is normally a reference switch on the tool magazine, if this is faulty the magazine cannot reference and position properly
A t b
Proximity switch on the swarf conveyor :-)
Hi, I think you need to check first your tool table and then the pocket table.
If a tool is in the pocket table in position 1-20 then your machine should then go to the magazine.
If the tool does...
Hi Mike
Both alarms one from the measuring systems, as there are two axes in error check the power supplies.
Best regards
Hi, you have to build the disk first, no ally there is a ghost image of the hard disk with the machine,fitted to the mmc and then the Dmg cycles loaded. Do you have any *.gho files on or with the...
Hi Garmata, check the measuring system as this is the cause of the Z02 alarm
All the best
Hi, this just says there is a tool in the tool gripper, depending on the version of machine, you may have a proximity switch on the gripper giving you an incorrect status. Check and see if there are...
Hi, the OS is only available from DMGMori, there are a number versions, once you fit the disk, you then have to rebuild the parameters from a backup. I do these in the uk and it is not something I...