Wow...you must be a mathematical genious. I tried to do this about 4 years ago and spent 6 months trying to develope an algorithm (and failed). I wrote about 1,500 lines of code and could never...
Type: Posts; User: geomagnet
Wow...you must be a mathematical genious. I tried to do this about 4 years ago and spent 6 months trying to develope an algorithm (and failed). I wrote about 1,500 lines of code and could never...
Thanks Art,
The manual says the G9 S[0-9] is a smoothing instruction. However, other sources say G9 is the exact stop instruction. So...I'm dumbfounded. WinCNC support has been helpful in...
Hello,
I leased a shop with a CNT Motion 5'x10' router table running WinCNC (on Dos). Yes, the machine is about 15 years old and has had better days. Over the past few months I have serviced the...
Sorry, my bad. I mis-read torchmate as Tormach.
I'm hoping they will become parts for a turbojet.
They take about two hours each and are somewhat
rough. I'm new at this so I really don't know how to
get a nice smooth finish. I assume you run...
Hello,
Yes, tormach took care of it fairly diligently. It required the Mach3 upgrade. The file should be available at the tormach site - http://www.tormach.com/document_library/PCNC3Rel1.4.exe
...
How would I test for a bad power supply or other driver card gone bad?
I hope I'm not stealing your thunder. But I've already built this about 4 years ago. Took a week and $200. It worked pretty good, but was very
difficult to register the other side (for two sided...
The parts are impellers, the code is quite large ~60,000 lines. From my understanding that's not too big. Furthermore, I've chopped out a portion of code 2000 lines and it still fails.
It's...
The problem is repeatable but variable, I finally got tormach to run the g-code and they had the same problem but worse. Its certainly a software issue and hopefully monday their experts will figure...
Hello,
I've owned my PCNC for a few months and I'm starting to get the hang of it...but it's now behaving unreliable.
I have been prototyping impellers out of aluminum, but started to have...
Hello,
I recently purchased a Tormach, but haven't any experience running
CNC machines. I'll gladly pay for time or trade for machine time to
someone local who can get me started. Flexible...
Check out http://www.moi3d.com
Super intuitive NURBS modeller absolutely FREE!!! I use intellicad and bryce but have never been able to model organic shapes until I downloaded MoI.
I then found a...