Does anyone have suggestions as what Sandvik grade would work well on AMS5666 (Inconel 625) for cut off and turning? I am having the cutoff insert chipping on the 5th part first chips on the bar...
Type: Posts; User: swissdodger
Does anyone have suggestions as what Sandvik grade would work well on AMS5666 (Inconel 625) for cut off and turning? I am having the cutoff insert chipping on the 5th part first chips on the bar...
Thank you.
Have a good day.
Have used Master cam, Gibbs and Partmaker. Partmaker is by far the best choice and their support is great. Have used it with Tsugami's; Citizen's; Star's ; and Turn-Mills over the past 16+ years.
I use Partmaker and the posts I have for our Stars very good.
Here is a good working program for thee SR32j. Main side first Hope this helps it should.
%
O4009
(PROGRAMMED BY STAR_SR_32J...
This will be my 1st time machining Bronze AMS 4590. Does someone have good starting surface footage for turning and drilling?
Thanks
Partmaker is definitely the way to go. I have been using it for over 15 years on Tsugami's, Citizens, Stars and Lathes. They have great and timely support.
Gibbs better suited for milling. Our...
Ideas for speed and feeds for drilling, and turning Stellite.
1 inch down to .720 and .529 hole about .55 length?
Thanks
Have been getting 926 FSSB Alarm on my Star SB16D when it sits idle for a little while.
It will re-boot and be fine. I cannot find what the alarm is - anyone know?
Thanks
Thank you sorry the tailstock interlock was on. this one machine has this issue but our other one is fine.
Have a good day.
Am getting EX0029 Tailstock Quill is not out alarm at start of program(had run fine yesterday and last night) and will not run.
and EX0461 Tailstock out Swiitch is Abnormal alarm on Mori ZL153
Thanks, I was thinking around 30. Good to know on the right track
I have a job that includes single point threadingthe I.D. in 718 inconel heat treated to about 35-40 Rockwell-suggestions for starting sfm??
Thank you, will post yea or nay later. Good day
Yes Absolutely
We have a Star SR-32J swiss and are looking for at least 2 ER20 collet holders with 32mm body that have coolant thru capability. Does anyone know who might make them and/or where to get them or get...
On our SR32J,SR-20's and SB-16's the manuals say M151 thru M159 on, BUT for all of ours it is M161 thru M169 = ON and M171 thru M179 = OFF.
Good Luck
Does anyone know of a vender that sells/makes drills, for example, ER-16 collets that have a 3/8 shank with a drill size of say .450 or .500? or am I resigned to spinning down the shanks in my tool...