Search:

Hello,

I recently upgraded my Gantry 3 controller board and software interface to Ver1.423.15 . Additionally added a 4th axis.
However I can't seem to get programs from VisualMill to run the...

Hello Eric,

Thanks for straightening me out on the Techno features! At this point in the discussion it might be better to continue privately.

However minor, I do take issue with using CAM for...

Hello Eric,

Thank you helping, but I'm not sure that knowing the answer makes the decision any easier :-(

I had no intention of going the Galaad route. I sounds too 'mickey mouse'. Only offered...

Hello Eric,

I've been researching this and I'm coming to the conclusion that If I want to keep to my wishlist I'll have to move away from the Techno-Isel system.
Because, the PCI or ISA cards I'm...

Hello Eric!
I'm looking to overcome the hardware and software limitations of the obsolete system without breaking the bank.
Upgrade the machine to have 4th axis plus spindle control while keeping...

Thanks again Al!
Your attachment expands my understanding of the issue.
Actually I just came across some Techno documentation that describes one pin (an auxiliary output) on the controller as...

Thanks Al,
Just to understand... my limit switches are being supplied +24V, therefore the supply is sinking input. And, I would need a sinking BOB.

Is that correct?

Hello all!

I have a vintage 1999 Techno-Isel gantry type machine with a servo system.
It runs on a PC card and a SRVBOX2 controller (+/-10V amplifiers).
In order to upgrade the PC card and keep...

Hello GizmoCNC
Would you be interested in parting with any motor and cable sets from the old set. I'm looking for Electrocraft E 242 or E243 servos.
If so you can PM me.
ShopWorks07