Search:

there has been some interesting comments and reasons for safety
mentioned and thanks to all for the points made.

i just want to say that when my machine is not working i always
activate my Estop...

just checked on mine and i actually put it back on so yep different to what
the manual says but works perfectly .

worked by removeing the pin as per manual but mine worked
as it should reading...

also if you are concerned about the voltage you could hook up a relay

so your dcm and FOR connections to input of relay and then use you 5v
supply to feed so the 5v+ to the relay 5V- to dcm and...

here are some pictures on mine setup look at the wire colours to help
its a bit of a mess only temporary while waiting for the new shielded cables to turn up


...

im just following what the connection recommendations from
the manual for the axbb-e have shown.

https://i.postimg.cc/BLw3C4hx/vfd.png

finally got it going no relay needed

removed jumper then

A01 = VI
ACM = 5V0
DCM = 24V0
FOR = pin 7 port 1
REV = pin 8 port 1

thanks was hopeing it would be a simple connection .

ok i have read as much as i can make sense of but for the life of me can not get it going.

i just got a AXBB-E and switched to uccnc from mach3 , i had it running via the rs485 plugin
but now...

i just got a AXBB-E and for the life of me i cant get it to
work. Really no documentation on the connections required.

I had it working with mach3 and lightburn on my old gerbl board.


it is...